Hi All,

I have been trying out the Corner Radius property on W\SW\Labels. Whilst on initial setup it works fine. I find that if I set a single corner radius or perhaps even two, if I am then connected to a session or even offline and hit the start button to view\insert live data etc all corner radius of the given object will then be set to the same value, rounding off all the corners.

In the attached images, I had set the 1st and 4th values to 45. After hitting the play button to view live data, all 4 values were then set to 45, rounding all the corners.

I think this is a bug. I would love to use the corner radius property as it would make things very simple. Any help would be much appreciated.

Regards,
Alex.

On a forum bug note, why can't I add images to the first post of a new thread. 3rd time fail for me. 2nd post works fine...see below images.

---

I thought I should show the effect that I was actually after and had set prior to the values being altered by the editor.

---

Probably a bug, I'll take a look.

Ok, I found the bug, it has to do with the override corner radius property. I have fixed it, but that means the override corner radius is no longer as useful (you cannot bind it to a numeric value anymore). I might as well remove it now, it is pretty useless, but I'll leave it in just in case someone finds it useful...

Thanks Nick,

Much appreciated.